1. 35 mm. blade with straight edge in closing
2. Swing / 7 cm. frame
3. Supplement Swing / Frame 7 cm.
4. Tapeta / Jamb flat 7 cm.
5. Precerc
6. PIVOTECK fittings
7. Crank
8. Partition
9. Polyurethane foam padding

1. Melamine sheet 30 mm.
2. Refolded leaf in beech wood vap. 40 mm.
3. Supplement Swing / Frame 7 cm.
4. Tapeta / Jamb flat 7 cm.
5. Precerc
6. PIVOTECK fittings
7. Crank anti-hook
8. Partition work
9. Polyurethane foam filling
10. Swing / Frame 7 cm.

Face the sheet towards the frame making the lower anchoring pieces coincide, the concavity of the piece installed on the sheet should be placed on the hemispherical part of the angular foot that rests on the floor and that, at the same time, is screwed to the frame.

Bring the top of the sheet to its vertical position. The leaf anchor pivot will shoot into its normal position as soon as it finds the top hole in the frame. Make sure that the anchor pivot is fully fired; This is checked with a fine screwdriver, 3 mm. in diameter, which is inserted through the hole that is located on the edge of the blade, on top of it. If the screwdriver enters an inch or so, it means that the pivot is not properly anchored and the blade could come off; in this case remove the sheet and repeat the process again to avoid the detachment of the sheet as well as the possible damages that this could cause.

To remove the blade, insert a 3 mm. diameter screwdriver into the hole in the upper part of the edge of the blade. Press hard while swinging the screwdriver up and down, making it advance in the anchor piece. When the screwdriver has been inserted one or two centimeters, the blade will be free and can be removed. Hold the door with your free hand to prevent it from falling and remove it carefully.

These descriptions are intended to define the PIVOTECK components as well as their operation. However, the doors are supplied in block or kit, according to specific needs, completely finished and therefore properly machined, varnished and packed, ready for assembly.